普光气田含硫污水尾气处理工艺应用与优化

针对中国石化普光气田产出水属于典型的含硫污水,密闭处理系统中产生大量高含硫尾气,论述了尾气处理工艺中存在的问题,优化了单一的生物除硫、活性炭吸附工艺,增加了一级碱洗、氧化除硫工艺,实现尾气达标排放。     

亚甲基蓝分光光度法测定废水硫化物的不确定度评定研究

分析了应用亚甲基蓝分光光度(GB/T16489-1996)测定废水硫化物测试过程中不确定度影响因素,主要来源为硫化物标准溶液、标准曲线拟合、随机效应、分光光度计和取样体积这五部分。本测量合成相对标准不确定度0.025 9;其中由测定样品质量引入的不确定度为0.024 7;由样品体积引入的不确定度为0.007 7。本次废水中硫化物测量结果为:0.110±0.006 mg/L,k=2(包含概率约为95%)。     

Shewanella oneidensis MR-1对硫化汞的生物利用性研究

在实验室模拟条件下,研究了铁还原菌奥奈达希瓦式菌Shewanella oneidensis MR-1对固态硫化汞的生物溶解、生物甲基化作用及其影响因素.结果表明,铁还原菌S.oneidensis MR-1在含硫培养基中生长良好,低浓度硫素能够促进其生长,高浓度时细菌生长则受到抑制,这种抑制主要表现在菌株生长曲线迟缓期的延长;铁还原菌S.oneidensis MR-1能够利用固态硫化汞,促进其溶解并迅速进行汞甲基化;在S.oneidensis MR-1的耐硫化物范围内,菌株对硫化汞的生物溶解作用随着硫化钠浓度的增大而增强,但生物甲基化作用只在低浓度硫化钠时受到促进,硫化钠浓度过高时则会受到抑制;此外,弱酸性环境比酸性及中碱性的环境更有利于S.oneidensis MR-1对硫化汞的生物溶解及甲基化.     

一种新型"Turn-on"荧光探针用于硫化氢可视化检测

硫化氢(H2S)是表征水体污染的重要参数之一,对其进行快速、有效地检测十分重要.荧光检测法由于具有不可比拟的优势得到了广泛的关注.以2-(2'-羟基苯基)苯并咪唑为荧光团,基于H2S的亲核性,设计合成了一种新型检测H2S的荧光探针.该探针与H2S作用后,荧光强度随H2S浓度的增加逐渐增强,颜色由淡黄色变成紫色,因此能够进行可视化检测,可视化检测限为3μmol·L-1.探针的最佳激发/发射波长为320/460 nm,对H2S表现出了良好的选择性和很快的响应速度(5 min),在较宽的p H(6~9)范围内,仍然表现出较好的荧光性能,荧光检测限为6μmol·L-1.该探针为H2S的检测提供了新方法.     

含硫化合物对Methylosinus trichosporium OB3b生长和合成聚-β-羟基丁酸酯的影响

为了将人类活动排放的含有甲烷的废气用于聚-β-羟基丁酸酯(PHB)合成过程,以M.trichosporium OB3b为菌种,考察硫化氢(H2S)和甲硫醚(DMS)对甲烷氧化菌生长和PHB合成的影响。实验结果表明,H2S浓度高达2 500μmol/mol时对甲烷氧化菌生长及甲烷单加氧酶(MMO)活性基本无影响,含H2S时的PHB含量和产率比无H2S时高,甲烷氧化菌经H2S培养后PHB合成能力增强。然而,DMS浓度为200μmol/mol时即可明显抑制甲烷氧化菌的生长及MMO活性。在DMS存在条件下,PHB含量和PHB产率都明显降低,经DMS培养后甲烷氧化菌的PHB含量进一步降低。     

微生物燃料电池处理含S2-/NH4+废水的研究

以除硫硝化微生物燃料电池(Microbial Fuel Cell,MFC)处理含S~(2-)/NH_4~+的模拟无机废水,研究了不同进水S~(2-)浓度下MFC的产电性能、污染物去除效果和阳极室硫累积情况.结果表明,除硫硝化MFC可实现同步阳极除硫和阴极硝化,并通过非生物电化学作用和生物电化学作用共同产电.进水S~(2-)浓度为(60.8±2.9)、(131.7±2.4)、(161.7±4.5)和(198.1±3.1)mg·L~(-1)时,最佳阳极碳刷清洗周期分别为3、3、3、4个换水周期,前3个进水浓度下的换水周期可分别缩短为6、8和8 h.MFC阴极硝化完全,不受进水S~(2-)浓度影响,但氧从阴极向阳极的渗漏导致阳极库仑效率较低(40%).适当增加进水S~(2-)浓度可增强MFC的产电性能并提高S~(2-)去除负荷和颗粒硫累积比.除硫硝化MFC适宜的进水S~(2-)浓度为(161.7±4.5)mg·L~(-1),相应的最大功率密度为5.77 W·m~(-3),周期产电量为(141.0±5.2)C,S~(2-)去除负荷为(0.31±0.00)g·L~(-1)·d~(-1),颗粒硫累积比达58%.阳极碳纤维丝上沉积有粒径约100 nm的颗粒硫.阳极悬浮物与沉积物相比,悬浮物中S0含量比例较高,而S6+含量比例较低.     

菌株Desulfovibrio sp. CMX的DNRA性能和影响因素

微生物的硝酸盐异化还原为铵(DNRA)过程对自然界中铵根离子的存在和转化具有重要影响,然而关于SRB菌株DNRA过程影响和机制尚未探明.本文考察了实验室筛选的SRB菌株Desulfovibrio sp.CMX的DNRA能力、影响因素及其影响机制.结果表明,无外加氮源的情况下,分别以10 mmol·L-1NO_3~-和NO_2~-作为唯一电子受体,菌株Desulfovibrio sp.CMX最终NH_4~+生成率分别达到85.8%和97.3%,且无N2和N2O等副产物产生.实验探究了不同外加氮源、不同初始浓度的SO_4~(2-)、S~(2-)对菌株DNRA过程的影响.酵母浸粉作为外加氮源可促进菌株的生长和代谢从而促进菌株DNRA过程;SO_4~(2-)对于NO_3~-还原为NO_2~-阶段起促进作用,而对NO_2~-还原为NH_4~+阶段起抑制作用,综合两方面影响,最终表现出对菌株DNRA过程的抑制作用;S~(2-)对菌株生长及DNRA过程都表现出抑制作用,且S~(2-)浓度越高抑制作用越强,当S~(2-)浓度达到6 mmol·L-1后,S~(2-)对于NO_3~-还原为NO_2~-阶段的抑制作用强于NO_2~-还原为NH_4~+阶段的抑制作用,NO_3~-还原为NO_2~-速率低于NO_2~-还原为NH_4~+速率,此时体系中不再有NO_2~-的积累.     

Biogenic volatile organic compound analyses by PTR-TOF-MS: Calibration, humidity effect and reduced electric field dependency

Green leaf volatiles(GLVs) emitted by plants after stress or damage induction are a major part of biogenic volatile organic compounds(BVOCs). Proton transfer reaction time-of-flight mass spectrometry(PTR-TOF-MS) is a high-resolution and sensitive technique for in situ GLV analyses, while its performance is dramatically influenced by humidity, electric field,etc. In this study the influence of gas humidity and the effect of reduced field(E/N) were examined in addition to measuring calibration curves for the GLVs. Calibration curves measured for seven of the GLVs in dry air were linear, with sensitivities ranging from 5 to10 ncps/ppbv(normalized counts per second/parts per billion by volume). The sensitivities for most GLV analyses were found to increase by between 20% and 35% when the humidity of the sample gas was raised from 0% to 70% relative humidity(RH) at 21°C, with the exception of(E)-2-hexenol. Product ion branching ratios were also affected by humidity,with the relative abundance of the protonated molecular ions and higher mass fragment ions increasing with humidity. The effect of reduced field(E/N) on the fragmentation of GLVs was examined in the drift tube of the PTR-TOF-MS. The structurally similar GLVs are acutely susceptible to fragmentation following ionization and the fragmentation patterns are highly dependent on E/N. Overall the measured fragmentation patterns contain sufficient information to permit at least partial separation and identification of the isomeric GLVs by looking at differences in their fragmentation patterns at high and low E/N.     

连续流动法测定沉积物中的酸挥发性硫化物

优化沉积物中酸挥发性硫化物(Acid Volatile Sulfide,AVS)的提取方法并采用连续流动分析法检测提取液中的硫化物.研究了吸收液的种类、氮气流量与吹气的时间和反应温度对AVS提取效果的影响以优化提取方法.结果表明,与传统的氢氧化钠或硫酸镉-氢氧化钠吸收液相比,以氯化锌-羧甲基纤维素钠溶液为吸收液吸附效率好,稳定性高且无毒.用连续流动分析法检测提取液中的AVS快速、准确、稳定性好.     

Dynamic behaviour of direct spring loaded pressure relief valves in gas service: II reduced order modelling

A previous study of gas-service direct-spring pressure relief valves connected to a tank via a straight pipe is continued by deriving a reduced-order model for predicting oscillatory instabilities such as valve flutter and chatter. The reduction process uses collocation to take into account a finite number N of acoustic pressure waves within the pipe, resulting in a set of 2N+3 ordinary differential equations. Following a novel non-dimensionalization, it is shown analytically that the model can exhibit, at experimentally realistic parameter values, instabilities associated with coupling between the valve and acoustic waves in the pipe. The thresholds for each instability are such that for a given flow rate, the first mode to go unstable as the inlet pipe length increases is the quarter-wave mode, then a three-quarter wave, a 5/4-wave etc. Thus the primary mode of instability should always be due to the quarter wave. In the limit of low flow rates, a simple approximate expression is found for the quarter-wave instability threshold in the form of inlet pipe length against mass flow rate. This threshold curve is found to agree well with simulation of the full model. For higher flow rates there is a need to include fluid convection, inlet pressure loss and pipe friction in order to get good agreement. The reduced model enables the dependence of the stability curve on key dimensionless physical parameters to be readily computed.